fokiparts.blogg.se - Stamp creator express

Stamp creator express pro#
Stamp creator express software#
Stamp creator express windows#

When data has been cleared, the message “READY” appears in the LCD.The message “INITIALIZE” appears in the LCD. Turn the machine off, then on again to initialize it.

Stamp creator express pro#

The Stampcreator Pro has different modes for performing different operations.įollow the operations described below to select the desired mode. could void the user’s authority to operate the equipment. Changes or modifications not expressly approved by Brother Industries, Ltd.

Stamp creator express software#

All other software and product names mentioned are trademarks or registered trademarks of their respective companies.

Stamp creator express windows#

Microsoft ® and Microsoft Windows ® are registered trademarks of Microsoft Corp.

Do not touch any of the machine’s internal sensors.

To prevent dust from entering the machine, do not leave the machine for a long period of time with the ink ribbon compartment cover or stamp compartment cover open or the xenon lamp unit or draft sheet magazine tray uninstalled.

Do not touch the machine’s internal parts since they can become extremely hot after the machine has been used for a long period of time.

Make sure that the power requirements specified for this machine are met.

Only lift the machine by grabbing the specified areas.

Do not use cleaning devices other than the print head cleaning pen and cleaning sheets supplied with the Stampcreator Pro.

Do not place the stamp on its side immediately after it is assembled.

Do not stand the stamp upside down immediately after it is assembled.

Do not reuse the ink pad as ink will have permeated the pad surface.

Do not remove the clear protective film before engraving a stamp.

Do not touch the printed draft sheet before creating a stamp.

Do not put heavy objects on the CD ROM.

Be careful that the CD ROM is not scratched.

Do not look directly at the flash from the xenon lamp unit.

Do not use folded or damaged draft sheets, ID labels, or cleaning sheets.

Store the draft sheets, ID labels, and cleaning sheets in their packages.

When connecting and disconnecting the cables, always be sure to grab the connectors, not the cords.

Do not try to disassemble the machine or any of its accessories.

Do not expose the machine, or any of its accessories, to extreme temperatures or high humidity.

Dust and dirt can cause distortion to the stamp image.

Keep the machine and its accessories out of direct sunlight and extremely dusty places.

Be sure the machine is always placed on a level, stable surface.

The enclosed interface cable should be used in order to ensure compliance with the limits for a Class B digital device.

Consult the dealer or an experienced radio/TV technician for help.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Increase the separation between the equipment and receiver.

Reorient or relocate the receiving antenna.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. TEL: (908) 704-1700 declares that the product:īrother Stamp Creation System “Stampcreator Pro”Ĭomplies with Part 15 of the FCC Rules. įederal Communications Commission (FCC) Declaration of Conformity (For USA Only)īrother International Corp. Removing a jammed draft sheet or ID label Importing graphics from a scanner, digitalĬamera, or other clip art source. Ĭhanging the character size of a text block.